General Procedure; Unpacking The Device - Siemens SIMATIC NET RUGGEDCOM MX5000RE Installation Manual

Installing the Device
2.1 General Procedure
2.1

General Procedure

The general procedure for installing the device is as follows:
IMPORTANT
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Install the fan tray.
11. Install the patch panels.
12. Connect network cables to the patch panels.
13. Install the front panel.
14. Mount the RUGGEDCOM MX5000RE.
15. Connect power to the device and ground the device to safety Earth.
16. Connect the device to the network.
17. Configure the device.
2.2

Unpacking the Device

When unpacking the device, do the following:
1.
2.
3.
IMPORTANT
If any item is missing or damaged, contact Siemens for assistance.
10
Review the relevant certification information for any regulatory requirements.
For more information, refer to
Review the RUGGEDCOM MX5000RE Modules Catalog [https://
support.industry.siemens.com/cs/ca/en/view/109748481]
or regulatory requirements related to the modules installed in the device.
Install the power supply patch cables.
If necessary, install the RUGGEDCOM MX5000 chassis ground connection.
Connect the failsafe relay and connect the patch cables.
Install the fan tray cables.
Install the mounting brackets.
Install the EMI gaskets.
Assemble the RUGGEDCOM MX5000 with the enclosure.
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
"Approvals (Page 47)".
Installation Manual, 01/2021, C79000-G8976-1060-13
for special installation
RUGGEDCOM MX5000RE