Installing/Removing Power Supply Modules - Siemens SIMATIC NET RUGGEDCOM RX5000 Equipment Manual

•
•
•
2.7.1

Installing/removing power supply modules

The RUGGEDCOM RX5000 supports dual redundant power supplies that can be
installed in any combination.
1
2
Figure 2.6
Contamination hazard – risk of equipment damage
Prevent the ingress of water, dirts and other debris that may lead to premature
equipment failure. Always make sure slots are not left empty.
Hot swapping power supply modules
Power supply modules are hot swappable. Hot swapping allows you to exchange
power supply modules that have the same voltage rating while the device is
powered by the redundant power supply module
RUGGEDCOM RX5000
Equipment Manual, 11/2023, C79000-G8976-1058-15
For 125/250 VDC rated equipment, an appropriately rated DC circuit breaker
must be installed.
It is recommended to provide a separate circuit breaker for each power module
module.
Equipment must be installed according to applicable local wiring codes and
standards.
1
Power supply module (PS1)
Power supply module (PS2)
Power supply modules
NOTICE
NOTICE
2.7.1 Installing/removing power supply modules
Installing the Device
2
23