Nortel 600 Series Manual page 68

2-61 Switch settings for printed circuit packs
Figure 2-37: NT3T87 BB Input/Output Interface paddleboard - switch locations
NTP 297-3601-316
Note: The NT3T87 BB paddleboard on the backplane of the IOI or GPIO shelf
contains a DIP-switch (S1) that selects the shelf address. The right switch (also
known as S1.1) on this DIP-switch must be set in the "up" position when the
paddleboard is provisioned on the IOI shelf. When the paddleboard is provisioned
on the GPIO shelf, this switch must be set in the "down" position. The left switch
(also known as S1.2) on this DIP-switch is not used.
For Generic 602.20
IOI
S1
GPIO
08.01 August 2006