Nortel 600 Series Manual page 59

Table 2-AY:
NT3T80AA (Series A-E) Dual Serial Data Interface pack - switch settings for TTY assignment
Device Number
2-3
4-5
6-7
8-9
10-11
12-13
14-15
Table 2-AZ:
NT3T80AA (Series A-E) Dual Serial Data Interface pack - switch settings for baud rate
assignment
Device Speed (Baud)
110
150
300
600
1200
2400
4800
9600
August 2006
Note 1: Settings: 1 = ON, 0 = OFF, - = NOT APPLICABLE.
Note 2: Device numbers 0 and 1 are preassigned to the NT3T71 TTY ports.
Therefore, they cannot be used for the NT3T80.
CAUTION: Incorrect address settings may cause system problems and a serious
degradation of service. For example, setting a device (TTY) address on the
NT3T80 to "- 1 1 1" will result in conflicts because this is the preassigned address
setting for TTYs 0 and 1 on the NT3T71 pack. Likewise, duplicating an address
setting for two different devices (TTYs) on two different NT3T80 packs will
result in conflicts.
Note 1: Settings: 1 = ON, 0 = OFF, - = NOT APPLICABLE.
Note 2: Eight data bits can be input and output by serial data interface (SDI)
hardware. The parity bit is not used. One stop bit is used for all settings except
110 baud, which selects two stop bits. The DMS-10 system software handles
OUTPUT and INPUT streams according to how the SDI port is assigned in the
DMO field as follows:
For Generic 602.20
Switch settings for printed circuit packs
Address Switches
1
-
-
-
-
-
-
-
Speed Switches
1 2
- 1
- 0
- 1
- 0
- 1
- 0
- 1
- 0
08.01
2 3 4
1 1 0
1 0 1
1 0 0
0 1 1
0 1 0
0 0 1
0 0 0
3 4
1 1
1 1
0 1
0 1
1 0
1 0
0 0
0 0
NTP 297-3601-316
2-52