Nortel 600 Series Manual page 135

Table 2-DW:
QRY18 Office Repeater pack - switch settings for the line build-out option
Option
Line build-out option OUT
Line build-out option IN
Table 2-DX:
QRY18 Office Repeater pack - switch settings for the fault/locate output option
Option
Normal
Side 1
Side 2
Table 2-DY:
QRY18 Office Repeater pack - switch settings for the signal loopback option
Option
Loopback enabled
No loopback required
Table 2-DZ:
QRY18 Office Repeater pack - switch settings for the powering option
Option
Two-cable system in all offices
One-cable system in powering office
One-cable system in looping office
One-cable system in "Through" office
Table 2-EA:
QRY18 Office Repeater pack - switch settings for the powering option (QRY18A through D,
Series A and B only)
Option
Two-cable system in all offices
One-cable system in powering office
One-cable system in looping office
One-cable system in "Through" office
August 2006
Note: Set switches toward option to be selected.
Note: Set switches toward option to be selected.
Note: Set switches toward option to be selected.
Note: Set switches toward option to be selected.
Note: Set switches toward option to be selected.
For Generic 602.20
Switch settings for printed circuit packs
08.01
Switch 3 Position
N
P
Switch 7 Position
W, Y
Y, X
W, Z
Switch 6 Position
S, U
T, V
Switch 10 Position
E, K, G, M
J, F, L, H
J, F, L, H
J, F, G, M
Switch 10 Position
J, F, G, M
J, F, L, H
J, F, L, H
E, K, G, M
NTP 297-3601-316
2-128