Table of Contents
Advertisement
Figure 42 Changing to Bridge mode
Note: You have to log in to the Web Configurator again when you change modes. As soon as
you do, your Multy M1 is already in Bridge mode.
When you select Bridge Mode, the following pop-up message window appears.
3
Figure 43 Pop up for Bridge mode
Click OK. Then click Apply. The Web Configurator refreshes once the change to Bridge mode is
successful.
6.8.1 Accessing the Web Configurator in Bridge Mode
Log in to the Web Configurator in Bridge mode, do the following:
Log into the Web Configurator. See the Quick Start Guide for instructions on how to do this.
1
Connect your computer to one of the LAN port of the Multy M1using an Ethernet cable.
2
Connect a modem/router to the WAN port of the Multy M1 using another Ethernet cable.
3
If the Multy M1 is not connected to a router or DHCP server, the Multy M1 cannot assign your computer
4
an IP address.
After you've set your computer's IP address, open a web browser such as Internet Explorer and enter
5
"http://(DHCP-assigned IP) as the web address in your web browser.
Chapter 6 Multy M1 Modes
Multy WiFi System User's Guide
130
Hide quick links:
Advertisement
Table of Contents
