Gateway MX7120 Service Manual page 87

10
Gently press outward on the clip at each end of the memory module until the module
tilts upward.
Clip
11
Pull the memory module out of the slot.
12
Hold the replacement module at a 30-degree angle and press it into the empty memory
slot. This module is keyed so it can only be inserted in one direction. If the module
does not fit, make sure that the notch in the module lines up with the tab in the
memory bay.
Important
13
Gently push the module down until it clicks in place.
14
Reassemble the notebook.
Replacing the memory module under the palm rest
Use only memory modules designed for the Gateway 7000 series,
M520, MX7000, or NX700.
www.gateway.com
Clip
83