Gateway MX7120 Service Manual page 83

12
Slide the brown memory card reader connector clip upward and remove the memory
card reader cable. Be careful not to touch or damage any other components.
13
Remove the old memory card reader from the notebook.
14
Place the new memory card reader into the notebook.
15
Make sure that the brown memory card reader connector clip on the system board
is in the raised position.
16
Insert the end of the memory card reader cable into the connector, then slide the
clip down.
17
Slide the memory card reader into the notebook, then replace the two screws in the
memory card reader removed in
18
Replace the memory card reader shield, then replace the three screws removed in
Step 9.
19
Reassemble the notebook.
Connector
Step 10.
www.gateway.com
Replacing the memory card reader
79