Gateway MX7120 Service Manual page 67

11
Lift the palm rest assembly up and away from the notebook.
12
Place the new palm rest assembly onto the notebook.
13
Make sure that the brown touchpad connector clip on the system board is in the raised
position.
14
Insert the end of the touchpad cable into the connector, then slide the clip down.
15
Replace the top palm rest screws removed in
16
Turn the notebook so the bottom is facing up.
17
Replace the black screws on the bottom of the notebook removed in
18
Reassemble the notebook.
Step
www.gateway.com
Replacing the palm rest assembly
9.
Step 8.
63