Table of Contents
Advertisement
DISASSEMBLY
"""
^
necessary, one screw may be backed out slight-
ly to level tool body.
4. As pressure is applied, alternately tap on the
front engine mounting boss, transmission
shafts, and shift cam.
Use soft hammer to tap on the case half. Tap
only on reinforced portions of case. Do not
tap on gasket mating surface. Work slowly
and carefully. Make sure the case halves
separate evenly. If one end "hangs up," take
pressure off the push screw. realign, and
start over. If the cases do not separate,
check for a remaining case screw or fitting.
Do not force.
r.
Shifter and Transmission
1.
Remove:
• Guide
bars
• Shift forks
• Shift cam
D
NOTE:
Note the position of each part. Pay particular at-
tention to the location and direction of shift forks.
re
If
2.
Install:
• 0-ringd)
3-15
Hide quick links:
Advertisement
Chapters
Table of Contents
