Yamaha DT200L 1984-1988 Service Manual page 101

ENGINE ASSEMBLY AND ADJUSTMENT ENG •
• Turn the adjusters 1/4 turn clockwise, and
tighten the locknuts (3).
• Remove the pin.
• Turn on the main switch, and check that the
aligning marks are aligned.
• If not aligned, repeat above steps.
8. Install:
• Power valve seal cap
5 Nm (0. 5 m. kg, 3. 6 ft. lb)
9. Connect:
• Clutch cable
NOTE:
After connecting the clutch cable, adjust the
clutch cable free play.
10. Connect:
• Oil delivery pipe
• Oil pipe
NOTE:
After connecting the pipes, bleed the air
11. Install:
• Oil pump cover
10 Nm (1.0 m. kg. 7. 2 ft. lb)
• Exhaust pipe
18 Nm (1. 8m. kg, 13 ft. Ib)
3-49