Yamaha DT200L 1984-1988 Service Manual page 195

(D
LIGHTING SYSTEM
ELEC
5. Accelerate the engine to specifications and
check the output voltage.
(g)
Do not run the engine in neutral above 6,000
r/min for more than 1 or 2 seconds.
CD Yellow
Black
Black
Red
6. Measure:
• Lighting voltage
Out of specification -" Perform the next test.
Lighting Voltage:
12 V or more 2,000 r/min
18 V or less 8,000 r/min
Lighting Coil Resistance Test
1. Remove:
• Fuel tank
2. Disconnect
• 3-pin connector (Sky blue, Yellow/Red
and White) (from CDI magneto)
• 2-pin connector (Brown and Black)
(from CDI magneto)
as^ 3. Connect:
• Pocket Tester (90890-03104)
Set the tester selector to "Ohm x 1"
position.
4. Measure:
• Lighting coil resistance
Out of specification — Replace.
Yellow/Red
Black
Lighting Coil Resistance:
0. 35 Q ± 20% at 20°C (68°F)
7-21