Yamaha DT200L 1984-1988 Service Manual page 110

COOL
WATER PUMP
3. Install:
• Components in above list (Disassembly-
Steps "5 and 4".)
4. Install:
• Crankcase cover (Right)
• Oil pump cover
Crankcase Cover and Oil
Pump Cover:
10 Nm (1.0m-kg, 7.2ft-lb)
Always use a new gasket.
5. Install:
• Joint pipe
NOTE:
When intalling the joint, grease the 0-rings on
the joint.
o 10 Nm (1.0m-kg, 7.2ft-lb)
Always use the new 0-ring.
6. Install/Fill:
• Components in above list (Disassembly-
steps "2 and 1".)
After warming up the engine, proceed as
follows:
1. Retighten the pump cover screws to
specification.
2. Check for coolant leakage, particularly
leakage into the transmission case.
4-7