Adjustment Procedure
* Figures on the graduations are indicated in the unit of mm.
1) Adjustment of forward feed stitch length
1. Turn the feed adjust dial ❶ in the direction of the arrow so that
the required figure is adjusted to the engraved marker dot of
the arm.
2. When changing the feed graduation from high to low, turn the
feed adjust dial ❶ while pressing the feed lever ❷ in the direc-
tion of the arrow and the feed adjust stopper ❸ in the direction
of the arrow (arm rear side).
3. When changing the feed graduation from low to high, turn the
feed adjust dial ❶ while pressing the feed adjust stopper ❸ in
the direction of the arrow (arm rear side).
4. When the feed adjust stopper ❸ is released, the feed adjust
dial ❶ is fixed .
2) Reverse feed stitch length check (manual)
1. Turn the feed adjust dial ❶ in the direction of the arrow so that
the required figure is adjusted to the engraved marker dot of
the arm.
2. Reverse feed takes place when the feed lever ❷ is pressed.
The status that the lever is pressed at the maximum corre-
sponds to the graduation value of the feed adjust dial ❶ .
3) Reverse feed stitch length check (electrically-operated)
1. When the switch ❹ is pressed, the sewing machine assumes
the condition of reverse feed. When this switch is released, the
condition of forward feed is promptly recovered.
Results of Improper Adjustment
– 32 –