Electrical Component And The Like; Control Box - JUKI DDL-8000A Engineer's Manual

6. Electrical component and the like

(1) Control BOX

⓭
Table 1 Input/output connector arrangement in control box
No. Connector
❶ J4 Regenerative resistor
J6 Main motor power
❷
❸ J7 Pedal sensor *
❹ J8 Main software rewrite
❺ J9 For production control
❻ J10 AC power input
J12 LED hand light/hand switch
❼
❽ J15 Panel I/F
❾ J17 Thread presser solenoid & optional output
❿ J18 Presser motor power/origin sensor
Thread trimming, reverse feed solenoid/oil
⓫ J19
quantity sensor
⓬ CN1 Main motor encoder
CN15 Presser motor software rewrite
⓭
* Applicable only to the standard pedal specification. Standing pedal specification is not available.
Table 2 Optional connector pin arrangement
No. Connector Pin
1 1 Suction solenoid valve (+)
2 2 Suction solenoid valve (–)
3 3 Thread hauling solenoid valve (+)
4 4 Thread hauling solenoid valve (–)
5 5
J17
6 6
7 Thread presser solenoid (+) Standard
7
8 Thread presser solenoid (–) Standard
8
9 9 Condensation solenoid (+)
10 10 Condensation solenoid (–)
❿
❾
❹
❺
❸
❻
Name of the destination to connect
Item
Needle thread
holdingsolenoid valve (+)
Needle thread
holdingsolenoid valve (–)
❼
❽ ❶
⓬
⓫
The connectors exist in the control box.
The connectors exist in the control box.
Housing arrangement
Remark
Fastening claw
JUKI part No.: HK034640000 HK034610100
Part name
Manufacturer Molex Inc
Model name of
functions
manufacturer
Remark
functions
This is different from the pin arrangement
specified by the manufacturer.
Refer to the figure above for pin arrangement
numbers.
– 105 –
❷
Remark
9 7
5 3
10 8 6 4
Pin contact Housing
Molex Inc
5556T 5557-NR
1
2