Pausing A Sonar Or Flasher Page; Marking A Waypoint - Garmin FishFinder 340C Owner's Manual

Pausing a Sonar or Flasher Page

Use a paused screen to take a better look at sonar returns. The
depth continues to update while the page is paused, but the
Fishfinder does not show any new sonar data until the Sonar Page
resumes scrolling. You might see a discontinuity from where the
sonar information stops to where it starts again when you resume
scrolling the screen.
To pause and unpause the Sonar or Flasher Page:
From the Sonar or Flasher Page, press PAUSE to stop the
scrolling. Press PAUSE again (or QUIT) to resume scrolling.
Fishfinder 340C Owner's Manual
U F 340C > P
SING THE ISHFINDER

Marking a Waypoint

You can use Pointer mode to move a cursor around on the paused
Sonar Page to reference sonar items and mark waypoints for
that location (if your Fishfinder is attached to a Garmin GPS or
compatible NMEA navigation device; see page 17). When you
use Pointer mode, a data field appears at the top of the graph with
the cursor's depth, surface temperature for that location, and GPS
coordinates (if available). This makes it easy to save the location of
an underwater object (such as a stump, rock, or brush pile), which
you can navigate back to with your GPS receiver.
To enable NMEA input/output:
1. Press and hold ADJ/MENU. The Main Menu appears.
2. Use the Rocker to select the System tab.
3. Use the Rocker to select the NMEA Input/Output field.
Press ENTER.
4. Use the Rocker to select On. Press ENTER. On appears in
the field.
5. Press QUIT to return to the previous page.
S F P
AUSING A ONAR OR LASHER AGE AND
M W
ARKING A AYPOINT
41