Garmin FishFinder 340C Owner's Manual page 16

I F 340C >
NSTALLING THE ISHFINDER
Mounting the Transducer on a Trolling Motor
(Dual Beam Only)
To mount the transducer on a trolling motor:
1. Slide the large cable tie through the slot on the transducer
mount (see the illustration on page 9) with the ridges of the
band facing up until equal lengths extend on both sides of
the mount. (NOTE: For cold water, or heavy timber or debris
areas, a metal 4-5" worm gear clamp is recommended.)
2. Position the mount gasket on the curved top of the
transducer mount.
Cable tie
Front of the transducer
10
M T
OUNTING THE RANSDUCER
3. Place the transducer assembly against the motor body of
the trolling motor, with the front of the transducer pointed
away from the trolling motor propeller.
4. Wrap the two ends of the cable tie around the motor body.
Place the pointed end of the cable tie through the fastener
hole on the opposite end and pull it through until it is snug
but not tight. (The cable tie clicks when you pull it.)
5. Position the transducer so that it is parallel with the bottom
when in use, and make sure the gasket is aligned properly.
Pull the cable tie end until tight. Trim off the excess, if
necessary. Tighten the 10-32 locking nut until it touches the
mounting bracket, and then tighten 1/4 turn more. (Do not
overtighten.)
6. Route the 30-foot (9 m) transducer cable using the supplied
cable ties to secure the cable to the motor shaft. You can
fill the forward-facing portion (except the cable tie pocket)
of the transducer mount with sealant to avoid accumulating
debris.
Fishfinder 340C Owner's Manual