Honda Accord 2020 Manual page 75

uuChild SafetyuSafety of Infants and Small Children
■
Installing a Child Restraint System with a Lap/Shoulder Seat Belt
74
1. Place the child restraint system on the
vehicle seat.
2. Route the seat belt through the child
restraint system according to the child
restraint system manufacturer's
instructions, and insert the latch plate into
the buckle.
u Insert the latch plate fully until it clicks.
Lap/shoulder seat belt with lockable retractor
3. Slowly pull the shoulder part of the belt all
the way out until it stops. This activates the
lockable retractor.
4. Let the seat belt retract several centimetres
and check that the retractor has switched
modes by pulling on the webbing. It should
not pull out again until it is reset by
removing the latch plate from the buckle.
u If you are able to pull the shoulder belt
out, the lockable retractor is not
activated. Slowly pull the seat belt all the
way out, and repeat steps 3 – 4.
1Installing a Child Restraint System with a Lap/Shoulder Seat Belt
To check if the lap/shoulder belt is equipped with the
lockable retractor, pull the shoulder part of the lap/
shoulder belt all the way out, let the belt retract
slowly, then pull the belt again gently. If the belt is
locked, the belt is equipped with the lockable
retractor.
Lap/shoulder seat belt with lockable retractor
The seat belt with a lockable retractor has a label as
shown in the image.