Ricoh Laser AP1600 Setup Manual page 41

A
Confirm that the box contains the
following items.
• HDD
• Operating Instructions Supple-
ment
B
Be sure to check the following
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
C
Remove the back plate.
Note
A coin can be used to remove
the screws.
Type 2 Printer: Installing Options
D
Align the screw holes of the HDD
over the screw holes where the
back plate used to be. Confirm
that the HDD is aligned as shown
in the illustration. Press the HDD
firmly against the printer. The in-
terface connectors on the printer
and the HDD should align and of-
fer a slight resistance before pop-
ping into place.
Note
A coin can be used to attach the
screws that were removed in
step C.
E
Plug the printer's power cord
back into the wall outlet and turn
on the printer's power switch.
After installing the HDD, use the
operation panel to have the printer
format the HDD.
F
Press { { { { Menu} } } } .
The following message appears on
the panel display.
Main Menu:
Job Control
2
TS4P091E
j
l
29