Table of Contents
Advertisement
Installing Options
D
Align the screw holes of Network
Interface Board over the screw
holes where the back plate used
to be. Confirm that the board is
aligned so that the jack is facing
out and is on the bottom. Press the
board firmly against the printer.
The interface connectors on the
2
printer and the board should
align and offer a slight resistance
before popping into place.
Note
A coin can be used to attach the
screws.
E
Loop the network interface cable
and attach the ferrite core as
shown in the illustration.
Note
The network interface cable
loop should be about 15 cm (6")
(A) from the end of the cable
(on the end closest the printer).
The ferrite core at the end of the
cable should be a ring type fer-
rite core.
28
1
F
Attach the network interface ca-
ble to the jack on the board as
shown in the illustration.
G
Connect the other end of the net-
work interface cable to the net-
work.
H
Plug the printer's power cord
back into the wall outlet and turn
on the printer's power switch.
The configuration page of Net-
work Interface Board will be print-
ed
automatically.
configuration of Network Inter-
face Board with it.
Important
After installing Network Inter-
face Board properly, set up the
printer's network environment
using the operation panel. See
P.35 "Configuring the Printer for
the Network".
Type 2 Printer: Installing Hard
Disk Drive Type 2000
Note
See the inside front cover of this
manual to confirm which printer
(Type 1 Printer or Type 2 Printer)
you have.
Check
the
Advertisement
Table of Contents
