Ricoh Laser AP1600 Setup Manual page 31

A
Confirm that the box contains the
following items.
• Network Interface Board
• CD-ROM
• Ferrite Core
• Installation Guide
• Quick Configuration Guide
• Additional Documentation
B
Be sure to check the following
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
C
Remove the back plate.
Note
A coin can be used to remove
the screws.
D
Align the screw holes of Network
Interface Board over the screw
holes where the back plate used
to be. Confirm that the board is
aligned so that the jack is facing
out and is on the bottom. Press the
board firmly against the printer.
The interface connectors on the
printer and the board should
align and offer a slight resistance
before popping into place.
Note
A coin can be used to attach the
screws.
E
Loop the network interface cable
and attach the ferrite core as
shown in the illustration.
BM3P080E
Note
The network interface cable
loop should be about 15 cm (6")
(A) from the end of the cable
(on the end closest to the print-
er). The ferrite core at the end of
the cable should be a ring type
ferrite core.
Type 1 Printer: Installing Options
1
2
19