Appliance Certification; Introducing The Heat & Glo Gas Fireplaces; Pre-Install Preparation; Approvals And Regulations - Heat & Glo PIER-HVB-CE Installer's Manual

1

Approvals and Regulations

Appliance Certification

The Heat & Glo fireplace models discussed in this Installers
Guide have been tested to certification standards and listed
by the applicable laboratories.
Certification
MODELS: PIER-HVB-CE, ST-HVB-CE,
LCOR-HVB-CE, RCOR-HVB-CE
LABORATORy: BSI
TyPE: Gas Fireplace
STANDARD: BS EN 613:2001 (Amd 1)
DIRECTIVE: GAD2009/142/EC
2

Getting Started

Introducing the Heat & Glo Gas Fireplaces
Heat & Glo direct flue gas fireplaces are designed to oper-
ate with all combustion air siphoned from outside of the
building and all exhaust gases expelled to the outside.
The information contained in this Installers Guide, unless
noted otherwise, applies to all models and gas control
systems. Gas fireplace diagrams, including the dimensions,
are shown in this section.

Pre-install Preparation

This gas fireplace and its components are tested and safe
when installed in accordance with this Installers Guide.
Report to your dealer any parts damaged in shipment,
particularly the condition of the glass. Do not install any
unit with damaged, incomplete, or substitute parts.
The flue system components are shipped in separate pack-
ages. The gas logs are packaged separately and must be
field installed.
Read all of the instructions before starting the instal-
lation. Follow these instructions carefully during the
installation to ensure maximum safety and benefit. Fail-
ure to follow these instructions will void the owner's
warranty and may present a fire hazard.
Heat & Glo • PIER/ST/L&RCOR-HVB-CE • 2068-900 Rev. o • 3/13

Installation Regulations

Before installation check that local distribution conditions,
nature of gas and pressure, and adjustment of the
appliance are compatible.
This appliance must be installed with the rules in force,
and used only in a sufficiently ventilated space. Consult
instructions before installation and use of this appliance.
The Heat & Glo Warranty will be voided by, and Heat & Glo
disclaims any responsibility for, the following actions:
• Installation of any damaged fireplace or flue system
component.
• Modification of the fireplace or direct flue system.
• Installation other than as instructed by Heat & Glo.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not manu-
factured and approved by Heat & Glo, not withstanding
any independent testing laboratory or other party ap-
proval of such component part or accessory.
ANy SUCH ACTION MAy POSSIBLy CAUSE A FIRE
HAZARD.
When planning a fireplace installation, it's necessary
to determine:
• Where the unit is to be installed.
• The flue system configuration to be used.
• Gas supply piping.
• Electrical wiring.
• Framing and finishing details.
• Whether optional accessories—devices such as a fan,
wall switch, or remote control—are desired.
If the fireplace is to be installed on carpeting, tile or
any combustible material other than wood flooring,
it should be installed on a metal or wood panel that
extends the full width and depth of the fireplace.
10