Placing The Ember Material - Heat & Glo PIER-HVB-CE Installer's Manual

LOG #6 (SRV582-705): Position log #6 on top of the groove in log #3 with the forked end resting on the grate
assembly as shown.

Placing the Ember Material

Ember material is shipped with this gas fireplace. To place
the ember material:
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
Figure 33.
• Remove the tension springs around the glass door.
• Remove the glass door from the unit.
• Remove the log set.
• Place dime size pieces of ember material about 1/2
inch apart near port holes in burner top. Do NOT place
embers over burner ports. Cover the top of the burner
with a single layer of ember material.
• Save the remaining ember materials for use during fire-
place servicing. The bag of embers provided is sufficient
for 3 to 5 applications.
• Install the Lava Rock (supplied) to the firebox base
pan being careful not to cover the burner with the Lava
Rock.
• Replace the logs, glass door, and a front trim door on
the unit.
37
6
Heat & Glo • PIER/ST/L&RCOR-HVB-CE • 2068-900 Rev. o • 3/13
Figure 34. Placement of Embers