Step 10. Installing Trim, Logs & Ember Material; Installing The Trim; Attachment Of Lower Door Assembly - Heat & Glo PIER-HVB-CE Installer's Manual

Step 10. Installing Trim, Logs & Ember Material

Installing the Trim

Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 149° C minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
!
NEVER OBSTRUCT OR MODIFy THE AIR IN-
LET/OUTLET GRILLES IN ANy MANNER.
Install optional marble and brass trim surround kits
as desired. Marble, brass, brick, tile, or other non-
combustible materials can be used to cover up the gap
between combustible material (sheetrock or wood) and
the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be lowered and the trim door removed.
wA R N I N G : C H I L D R E N A N D A D U LT S
!
SHOULD BE ALERTED TO THE HAZARDS
OF HIGH TEMPERATURES OF wORkING
SURFACES ON THESE FIREPLACES.
wORkING SURFACES INCLUDE ALL
GLASS PANELS AND DECORATIVE DOORS.
yOUNG CHILDREN SHOULD BE CAREFULLy
SUPERVISED wHEN THEy ARE IN THE SAME
ROOM AS THE APPLIANCE.
Log placement
Log Set Assembly: LOGS-ST-CE
Only for Models: ST-HVB-CE, PIER-HVB-CE and RCOR-HVB-CE
1 2 3
CAUTION: Logs are fragile. Carefully remove the logs from the packaging. Logs #4 and #5 are the same log.
See Service Parts pages for individual assembly photos.
4
6
5
Heat & Glo • PIER/ST/L&RCOR-HVB-CE • 2068-900 Rev. o • 3/13

Attachment of Lower Door Assembly

This unit is shipped with the door stops unattached to
assist in the set-up of the unit. After the gas and electrical
have been run, the door stops can be used if desired as
shown in Figure 32.
DOOR
STOPS
SHOULDER
BOLT
LOWER
DOOR
Figure 32. Lower Door Assembly
TABS
SHOULDER
DOOR
BOLT
STOPS
32