Adjust - Interlogix TruVision TVB-2403 Configuration Manual

RS-485
HEATCTRL

Adjust

Use this menu to configure sharpness, monitor settings, OSD settings, lens
shadow compensation, as well as to change the video output standard, etc.
Move the cursor to ADJUST and press OK to enter the menu.
Select the following options under the Adjust menu:
TruVision HD-TVI 1080P Camera Configuration Manual
AUTO: Detect and repair defective pixels automatically.
ON: Repair defective pixels manually, configurable range [0-255],
select higher value to repair the defective pixels easily,
OFF: Disable DPC function.
STATIC DPC: Detect and correct defective pixels manually. Select
On/Off to enable/disable.
1.START
2.LEVEL
3.SENS-UP
4.AGC
5.RETURN
START: Start detecting and correcting defective pixels.
Press OK when you see the message on the screen.
LEVEL: The STATIC DPC level ranges from 0 to 60. The higher
the value, the easier it is to correct defective pixels.
Some defective pixels may not be identifiable for the system to
detect. In such a situation, adjust the SENS-UP to X2, X4, X6,
X8, X10, X15, X20, X25 or X30 to brighten defective pixels and
facilitate the system to find them. Set the AGC level from 0 to 8.
Set the RS-485 parameters, including camera ID, ID display status
and baud rate (2400/4800/9600/19200/38400).
1. CAM ID
2. ID DISPLAY
3. BAUDRATE
4. RETURN
Note: Only the TVC-2401/4401camera has a RS-485 port and RS-
485 menu.
Heat control.
Select the heater mode as ON, OFF or AUTO.
OFF: Heater is disabled.
AUTO: The heater starts to work when the temperature falls
below -10 °C. When temperature increases to -5 °C, it will stop
working.
ON: The heater starts to work when temperature falls below
-40°C. When the temperature increases above -40 °C, the heater
will stop working.
Note: Only the TVB-2406/4406 camera has this function.
STATIC DPC
---|------15
x 20
---|------2
RET
RS485
--------|255
ON
2400
RET
17