Interlogix TVD-2401 Installation Manual

TruVision High Definition TVI Dome Installation
Guide

Product overview

This is the Installation Guide for TruVision High Definition TVI
dome TVD-2401/TVD-4401 and TVD-2403/TVD-4403. This
guide describes a standard installation.
Package contents:
Camera with power and

video output cables
Template

• WEEE and Battery
Disposal

Camera description

TVD-2401/TVD-4401
1.
Base
2.
IR LED
3.
Lens
4.
Dome liner
© 2015 United Technologies Corporation. All rights reserved.
Interlogix is part of UTC Building & Industrial Systems, a unit of United Technologies Corporation. All rights reserved.
3 screws and 3 anchors

for wall or ceiling
installation
Installation Guide

CD

5.
Housing
6.
Power supply
7.
TVI Video output cable (grey)
TVD-2403/TVD-4403
1. Base
2. IR LED
3. Lens
4. Dome liner
Note:
Please check the camera output settings before setting up a
system. The TVI video output can be only connected to DVR
with TVI signal input. The CVBS output supports the standard
monitor, test monitor, encoder and DVR.
For TVD-2403/TVD-4403, you can connect the white and black
line ends of the WDR switch cable to enable the Wide Dynamic
Range function. The WDR function is disabled by default. If
WDR is enabled, the CVBS output will be blocked out, and
only TVI output is available.
Installation
To install the camera on a ceiling:
1. Using the template, place it level against the mounting
surface and mark the position of the mounting holes.
1
1
A
Drill Template
Hole A: for cables routed through the ceiling
screw hole 1: for Mounting Base
1
2. Following all local codes, drill and prepare the mounting
holes.
P/N 1072939-EN • REV A • ISS 26MAR15
5. Housing
6. Power supply
7. TVI video output cable
(grey)
8. CVBS video output cable
(black)