Configuration File - ZyXEL Communications NWA50AX User Manual

While configuration files and shell scripts have the same syntax, the Zyxel Device applies configuration
files differently than it runs shell scripts. This is explained below.
Table 71 Configuration Files and Shell Scripts in the Zyxel Device
Configuration Files (.conf)
• Resets to default configuration.
• Goes into CLI
• Runs the commands in the configuration file.
You have to run the aforementioned example as a shell script because the first command is run in
mode. If you remove the first command, you have to run the example as a configuration file
Privile g e
because the rest of the commands are executed in
C o m m e nts in C o nfig ura tio n File s o r She ll Sc ripts
In a configuration file or shell script, use "#" or "!" as the first character of a command line to have the
Zyxel Device treat the line as a comment.
Your configuration files or shell scripts can use "exit" or a command line consisting of a single "!" to have
the Zyxel Device exit sub command mode.
Note: "exit" or "!'" must follow sub commands if it is to make the Zyxel Device exit sub
command mode.
In the following example lines 1 and 2 are comments. Line 7 exits sub command mode.
! this is from Joe
# on 2010/12/05
wlan-ssid-profile default
ssid Joe-AP
qos wmm
security default
!
Erro rs in C o nfig ura tio n File s o r She ll Sc ripts
When you apply a configuration file or run a shell script, the Zyxel Device processes the file line-by-line.
The Zyxel Device checks the first line and applies the line if no errors are detected. Then it continues with
the next line. If the Zyxel Device finds an error, it stops applying the configuration file or shell script and
generates a log.
You can change the way a configuration file or shell script is applied. Include setenv stop-on-error
off in the configuration file or shell script. The Zyxel Device ignores any errors in the configuration file or
shell script and applies all of the valid commands. The Zyxel Device still generates a log for any errors.
18.2 C o nfig ura tio n File
Click
Ma inte na nc e > File Ma na g e r > C o nfig ura tio n File
screen to store, run, and name configuration files. You can also download configuration files from the
Zyxel Device to your computer and upload configuration files from your computer to the Zyxel Device.
Chapter 18 File Manager
mode.
C o nfig ura tio n
NWA50AX User's Guide
Shell Scripts (.zysh)
• Goes into CLI
Privile g e
• Runs the commands in the shell script.
mode.
C o nfig ura tio n
to open this screen. Use the
168
mode.
C o nfig ura tio n File