ZyXEL Communications NWA50AX User Manual page 25

ZON Utility Screen
Fig ure 10
6
Select a device and then use the icons to perform actions. Some functions may not be available for
your devices.
Note: You must know the selected device admin password before taking actions on the
device using the ZON utility icons.
Password Prompt
Fig ure 11
The following table describes the icons numbered from left to right in the ZON Utility screen.
Table 4 ZON Utility Icons
IC O N
1 IP Configuration
2 Renew IP Address
3 Reboot Device
4 Reset Configuration to
Default
5 Locator LED
6 Web GUI
7 Firmware Upgrade
8 Change Password
Chapter 2 AP Management
DESC RIPT IO N
Change the selected device's IP address.
Update a DHCP-assigned dynamic IP address.
Use this icon to restart the selected device(s). This may be useful when troubleshooting
or upgrading new firmware.
Use this icon to reload the factory-default configuration file. This means that you will
lose all previous configurations.
Use this icon to locate the selected device by causing its
Use this to access the selected device Web Configurator from your browser. You will
need a username and password to log in.
Use this icon to upgrade new firmware to selected device(s) of the same model. Make
sure you have downloaded the firmware from the Zyxel website to your computer and
unzipped it in advance.
Use this icon to change the admin password of the selected device. You must know
the current admin password before changing to a new one.
NWA50AX User's Guide
25
LED to blink.
L o c a to r