ZyXEL Communications NWA50AX User Manual page 29

The following are the LED descriptions for your Zyxel Device.
Table 6 Zyxel Device LED
C O L O R ST AT US
Amber Blinks amber for 1 second
and green for 1 second
alternatively.
Green
Amber Blinks amber and green
alternatively 3 times and
Green
then turns solid green for 3
seconds.
Amber Blinks amber and green
alternatively 2 times and
Green
then turns solid green for 3
seconds.
Green Slow Blinking (On for 1
second, Off for 1 second)
Green Steady On
Bright Blue Steady On
Blue Slow Blinking (Blink for 1
time, Off for 1 second)
Red On
Fast Blinking (On for 50
milliseconds, Off for 50
milliseconds)
Slow Blinking (Blink for 3
times, Off for 3 seconds)
Chapter 3 Hardware
DESC RIPT IO N
The Zyxel Device is booting up or is connecting with NCC.
The Zyxel Device is discovering the NCC or an AC.
The Zyxel Device is managed by an AC but the uplink is
disconnected.
The wireless module of the Zyxel Device is disabled or fails, the
Zyxel Device is using default wireless settings, or the Zyxel
Device is configured to be managed by NCC but is not yet
registered with the NCC.
The Zyxel Device is ready for use, the Zyxel Device's wireless
interface is activated, and/or wireless clients are connected
to the Zyxel Device.
The Zyxel Device's wireless interface is activated, but there
are no wireless clients connected.
The Zyxel Device is performing a Channel Availability Check
(CAC) with Dynamic Frequency Selection (DFS) to monitor a
channel for radar signals.
The Zyxel Device failed to boot up or is experiencing system
failure.
The Zyxel Device is undergoing firmware upgrade.
The Uplink port of the Zyxel Device in standalone mode is
disconnected.
NWA50AX User's Guide
29