Resetting The Zyxel Device; Getting More Troubleshooting Help - ZyXEL Communications NWA50AX User Manual

• The load balancing task may have been terminated because further load balancing on the Zyxel
Devices in question is no longer required.
26.6 Re se tting the Zyxe l De vic e
If you cannot access the Zyxel Device by any method, try restarting it by turning the power off and then
on again. If you still cannot access the Zyxel Device by any method or you forget the administrator
password(s), you can reset the Zyxel Device to its factory-default settings. Any configuration files or shell
scripts that you saved on the Zyxel Device should still be available afterwards.
Use the following procedure to reset the Zyxel Device to its factory-default settings. This overwrites the
settings in the startup-config.conf file with the settings in the system-default.conf file.
Note: This procedure removes the current configuration.
1
Make sure the Power LED is on and not blinking.
2
Press the
RESET
seconds.)
3
Release the
You should be able to access the Zyxel Device in standalone mode using the default settings.
26.7 G e tting Mo re T ro ub le sho o ting He lp
Search for support information for your model at www.zyxel.com for more troubleshooting suggestions.
Chapter 26 Troubleshooting
button and hold it until the Power LED begins to blink. (This usually takes about ten
button, and wait for the Zyxel Device to restart.
RESET
NWA50AX User's Guide
205