Max-On Rx3I Component Installation - Emerson PACSystems RX3i User Manual

User Manual
GFK-2409B
•
•
•
•
Note:
1.1.4

Max-ON RX3i Component Installation

The default settings for the Max-ON RX3i software installation places the Max-ON RX3i
Software and the associated project components in the Emerson directory.
The Max-ON RX3i components are installed in the tree structure as shown below:
Figure 1:
The Max-ON RX3i Configuration Utility is located in Max-ON RX3i Tools directory. It is
launched by double-clicking on the Max-ON RX3i configuration file (config.mx3) located in
the PAC Logic Developer PLC project.
The default Max-ON RX3i Hot Standby Redundancy application project, named Max-ON
RX3i LD Project vx_yy.zip, is located in the Redundancy LD directory. This project must be
brought into your PAC Machine Edition development environment using PAC Machine
Edition's File > Restore Project... menu.
A PAC View Diagnostic project is in the Diagnostics VIEW directory. When it is active, this
diagnostic utility displays key information regarding the operation and state of the
redundant CPU pair. This project must also be brought into your PAC Machine Edition
development environment using PAC Machine Edition's File > Restore Project... menu.
Introduction
All files relating to Max-ON RX3i Software will be removed from the hard drive. Any
files used by both Max-ON RX3i Configuration Utility and another application will be
left on the system.
All registry entries relating to Max-ON RX3i Software will be removed from the
systems registry.
Icons for Max-ON RX3i Software will be removed from the Start Menu.
Any data you created (for example, Project that you have created) will be left on the
system.
You may also uninstall Max-ON RX3i Software by choosing Add/Remove Programs from the
Control Panel, then selecting Max-ON RX3i Tools
Chapter 1
Oct 2019
3