Chapter 3: Building A Max-On Rx3I Hot Standby Application; Max-On Rx3I Project; Project Workflow - Emerson PACSystems RX3i User Manual

User Manual
GFK-2409B
Chapter 3: Building a Max-ON RX3i Hot
3.1

Max-ON RX3i Project

Max-ON RX3i encapsulates your entire application within a single Machine Edition Project.
Using a generic Max-ON RX3i Project, you can create a new Max-ON RX3i Redundancy
project. The generic project contains all the base Max-ON RX3i redundancy application
components needed to perform the redundant application. You add the hardware
configuration information for each PLC in your application, add your application logic, and
define the parameters of the Redundant System using the Max-ON RX3i Configuration
Utility that us launched from the Logic Developer PLC Project.
Figure 12:
3.2

Project Workflow

Step 1 - Gather Information
Gather the information about your system:
•
•
•
•
Building a Max-On RX3i Hot Standby Application
Standby Application
I/O Bus topologies and addresses
Synchronization LAN locations
Module types and locations
I/O Devices including bus assignment, bus addresses, circuit references, number of
circuits and I/O family type.
Chapter 3
Oct 2019
14