Step 2 - Configure Ethernet Connections To The Plcs - Emerson PACSystems RX3i User Manual
Hide thumbs
Also See for PACSystems RX3i:
- User manual (232 pages) ,
- Application manual (37 pages) ,
- Manual (37 pages)
Table of Contents
Advertisement
User Manual
GFK-2409B
8.2
Step 2 – Configure Ethernet Connections to the
PLCs
In order to conduct data transfers between Max-ON RX3i Diagnostics and the Hot Standby
PLCs, you need to establish an Ethernet communication connection to the PLCs. To
configure the Ethernet addresses of the PLCs in the View Project:
1. Open the View project that was restored in Step 1.
2. Expand the PLC Access Drivers node in the Navigator for the View target and select
Figure 111
3. Modify the Address of PLCA in the Inspector to match the IP address of PLC A in your
4. Repeat step 3 for PLCB.
5.
Figure 112
Diagnostic Tools
the PLCA device.
Max-ON RX3i system.
Select the Download and Start Active Target toolbar button to start the Max-ON
RX3i Diagnostic program, or press the F9 key.
Chapter 8
Oct 2019
102
Advertisement
Table of Contents
