Configuring Plc A - Emerson PACSystems RX3i User Manual
Hide thumbs
Also See for PACSystems RX3i:
- User manual (232 pages) ,
- Application manual (37 pages) ,
- Manual (37 pages)
Table of Contents
Advertisement
User Manual
GFK-2409B
6.1
Configuring PLC A
Open the Hardware Configuration for PLC_A_HW
In the Max-ON RX3i Project, select and expand the Hardware Configuration node of
the PLC_A_HW target.
Figure 72
Set the Max-ON RX3i Identity for PLC A
The identity for CPU A is determined by the value set in the Logic Checksum Words
CPU parameter located in the CPU's Hardware Configuration for CPU A.
Open the CPU module's Hardware Configuration by double-clicking on the
IC695CMU310 module.
Click on the Scan tab to display the Logic Checksum Words parameter.
Verify that the Logic Checksum Words parameter value is 32. If it is not 32, change
the parameter to this value.
Verify that the Number of Last Scans is set to 1. If it is not 1, change the parameter
to this value.
Configuring the Hot Standby Redundancy CPUs
Chapter 6
Oct 2019
71
Advertisement
Table of Contents
