Configuring The Genius I/O Devices - Emerson PACSystems RX3i User Manual

User Manual
GFK-2409B
Figure 97
6. Set the EGD Local Producer ID in the controllers.
7. Create EGD Exchanges in the Primary controller (PLC A) to match the EGD
8. Create EGD Exchanges in the Secondary controller (PLC B) to match the EGD
9. If Remote COMMREQ Calls will be used with the ENIUs, add the RCC Parameterized
10. C Block to the PLC_COMMON_CODE target's application, and add any logic needed
11. Store the Hardware Configurations (PLC_A_HW and PLC_B_HW targets) to PLC A
12. Store the Application Logic (PLC_COMMON_CODE target) to PLC A and PLC B.
13. Verify that the EGD Exchanges are working.
14. Verify that any RCC commands are working.
15. Verify that any Local Logic is working.
7.2 Configuring the Genius, I/O Devices
Before you may use your system, you must configure the Genius I/O devices that are to be
installed on the Genius I/O bus.
You must configure each device for:
•
•
•
•
Configuring the I/O Devices
exchanges in each ENIU.
exchanges in each ENIU.
to execute these commands.
and PLC B.
Serial Bus Address (SBA)
Type of I/O (Input, Output, Combination)
Scaling
Defaults
Chapter 7
Oct 2019
87