Programming Function Keys; Erasing Programs - Furuno FSV-30 Operator's Manual

7. CUSTOMIZING THE EQUIPMENT
7.2.2

Programming function keys

You can change the default setting of a function key as shown below. Note that
all menu items may not be programmed to the function keys. See the menu tree
on page M-1 to M-4 for items which can be programmed for function keys.
1. Press the [MENU] key to open the menu.
2. Display the menu item which you want to assign to a function key.
3. Press desired function key for more than one second. The display shows the
following message for five seconds at the top of the screen.
4. Press the same function key again, and the following message appears. This
completes the procedure for programming a function key.
7.2.3

Erasing programs

1. Press the [MENU] key to open the menu.
2. Select OTHERS and press the [MENU] key.
3. Select PRESET, MEMORY CARD and press the [MENU] key.
4. Select CLEAR F-KEY SETTING and press the [MENU] key.
5. Select YES and press the [MENU] key to confirm the CAUTION indicated.
7-6
(FUNCTION KEY REGISTRATION)
REPLACE THE FUNCTION TO NEW
SETTING. PRESS THE KEY AGAIN
TO PROCEED.
Confirmation for registering function key
(FUNCTION KEY REGISTRATION)
REGISTRATION COMPLETED.
Confirmation for registering function key
MENU
OTHERS
PRESET, MEMORY CARD
ASSIGN USER PROG...
CLEAR F-KEY SETTING...
H-SCAN RANGE
V-SCAN RANGE
PICTURE SHOT : EXECUTE
PICTURE RECALL : EXECUTE
MEMORY CARD...
PRESET, MEMORY CARD menu
QUIT
QUIT
QUIT