Adjusting Beamwidth - Furuno FSV-30 Operator's Manual

3.10

Adjusting Beamwidth

The vertical beamwidth of the Rx beam can be adjusted on the OTHERS menu
to reduce surface reflections.
1. Press the [MENU] key to open the menu.
2. Select V-SCAN SETTING and press the [MENU] key.
3. Select OTHERS and press the [MENU] key.
4. Select BEAMWIDTH and press the [MENU] key.
5. Use the trackball to select ▲ (raise setting) or ▼ (lower setting) as
appropriate and press the [MENU] key. The setting range is 0 to 5. The
higher the setting the sharper the beamwidth.
6. Select QUIT and press the [MENU] key.
7. Select QUIT at the top of the menu screen and press the [MENU] key to
close all menus.
MENU
V-SCAN SETTING
OTHERS
COLOR : COLOR 1
COLOR SETTING...
COLOR RESPONSE : COLOR CURVE 3
COLOR RESPONSE...
GAIN OFFSET : 0
SIGNAL LEVEL : 0
FAR TVG CURVE TVG 2
TVG DISTANCE...
NEAR AGC DISTANCE: 200 m
nd
2 AGC DISTANCE : 0 m
SMOOTH ECHO RNG : 0
SMOOTH ECHO CIR : 0
BEAMWIDTH : 0
DISPLAY POSITION LEFT
VERTICAL SIZE FULL
OTHERS menu
QUIT
CANCEL
Dialog box
3. VERTICAL MODE
QUIT
QUIT
QUIT
3-13