Daikin Split Comfora R32 Service Manual page 114

2 | Components
To install the thermistor
Service manual
114
▪ Remove all other thermistors wired to the connector from their thermistor
holder,
▪ Disconnect the thermistor connector from the appropriate PCB,
▪ Remove the complete set of thermistors.
9 To install the thermistor, see
1 Pull the clip and install the thermistor in the specific thermistor holder. Make
sure the clip is in the correct position (blocking the thermistor).
c
a
f
f
a Clip
b Thermistor
c Thermistor holder
d Insulation
e Thermistor wire
f Tie strap
2 Connect the thermistor connector to the appropriate PCB.
INFORMATION
Some of the thermistors are wired to the same connector. See connector and pin
information of the thermistors at the start of the electrical check procedure and
"5.2 Wiring diagram" [
to the same connector.
"Repair procedures" [
b
e d
4
137]. ALWAYS replace the complete set of thermistors wired
ATXP20~35 + FTXP20~71 + ARXP20~35 + RXP20~71
4
112].
Split Comfora R32
ESIE18-01C – 2020.07