Using The Recording Timer - Sony Giga Juke NAS-E300HD Operating Instructions Manual

Using the Recording Timer

You can set the timer to automatically turn the
unit on and off at a specified time. The unit starts
recording a radio program or a DAB service*
automatically when it turns on. Make sure the
clock (page 22), the radio station (page 37), or the
DAB service* (page 37) must be set beforehand.
You cannot set the Recording Timer and Play
Timer to the same time.
* For the UK model only
1
Tune in the desired radio station or
DAB service.
2
Press CLOCK/TIMER SET, press  / 
to select "  REC SET", and then press
ENTER.
"REC" appears and the hour indication
flashes.
3
Set the time to start recording.
Press / to select the hour, and then press
ENTER so that the minute indication flashes.
Do the same procedure to set the minute.
To go back to the hour indication, press .
When you press ENTER after setting
the minute, "OFF" appears and the hour
indication flashes.
4
Set the time to stop recording.
Do the same procedure as step 3.

GB
5
Press  to turn off the unit.
About 60 seconds before the preset time, the
unit will automatically turn on, and about
10 seconds before, the Recording Timer will
activate. If the unit is already on at about 60
seconds before, the Recording Timer will not
be activated.
The volume is set to "MIN" while the
Recording Timer is in progress. Press
VOLUME + to listen to the sound.
To stop a timer recording
Press .
To continue playback after the
Recording Timer's stop time
You can cancel the Recording Timer setting while
the timer is operating. When you do this, the stop
time is cancelled and playback continues.
To cancel the setting, press CLOCK/TIMER
SELECT, press  /  to select "OFF", and then press
ENTER while the Recording Timer operation is in
progress. "TIMER OFF" appears in the display and
the stop time is cancelled.
To activate or check the timer again
Press CLOCK/TIMER SELECT, press  /  to
select "REC", and then press ENTER.
To cancel the timer
Press CLOCK/TIMER SELECT, press  /  to
select "OFF", and then press ENTER.
To change the setting
Start over from step 1.
Notes
 You cannot set a stop time for the Recording Timer that
is the same time as a start time. If you do, "OFF TIME
NG!" appears.
 If you want to record a DAB service using Recording
Timer, you should preset the service you want to record
in advance. If not, you will not be able to make the
setting.