Sony Giga Juke NAS-E300HD Operating Instructions Manual page 20

To insert the batteries into the
remote control
Slide and remove the battery compartment lid, and
then insert the two supplied R6 (size AA) batteries
( end first) matching the polarities as shown
below.
When the remote control is no longer able to
operate the unit, replace both batteries with new
ones.
Notes
 Mishandling of the batteries may result in battery
leakage or an explosion. Make sure to do the following:
— Insert the batteries with their + and – polarities
correctly positioned.
— Do not mix an old battery with new one, or mix
different types of batteries.
— Do not charge the batteries.
— Remove the batteries when not using the remote
control for a long period of time.
— If battery leakage occurs, wipe up the battery
fluid in the battery compartment and insert new
batteries.
 Keep the remote sensor away from strong light (such as
from the sun or lighting equipment). This may prevent
the remote control from operating the unit.
 With normal use, the battery should last about six
months. When the remote control is no longer able to
operate the unit, replace both batteries with new ones.
0
GB
To run the DAB Automatic Scan
When you turn on the unit for the first time after
you purchase the unit, DAB Automatic Scan
starts automatically and creates a list of available
services. If you want to run the DAB Automatic
Scan again, perform the procedure below.
This function is available on the UK model only.
1
Press DAB AUTO SCAN on the main
unit.
"Auto Scan?" and "Push ENTER" appear in
the display.
2
Press ENTER.
Scanning starts. "Auto Scan" appears.
Depending on the DAB services available in
your area, scanning may take a few minutes.
When scanning is completed, a list of available
services is created.
Notes
 If your region does not support DAB broadcast, "No
Service" appears.
 Do not press any button on the unit or the remote
control during DAB Automatic Scan. Scanning is
interrupted and service list may not be created properly.
In this case, run the DAB Automatic Scan again.
 If you move to another area, repeat this procedure to
store the stations for your new area.
 This procedure clears all previously stored presets.
 Before unplugging the DAB antenna, make sure the
unit is turned off to preserve your own DAB settings.
 This tuner does not support data services.
To attach the speaker pads
Attach the supplied speaker pads to the bottom
corner of the speakers to stabilize the speakers and
to prevent them from slipping.
or