Connecting The Speakers And Antennas - Sony Giga Juke NAS-E300HD Operating Instructions Manual

Connecting the speakers and antennas

Speaker cords
Press down on the tab below the terminal, and insert
the end of the cord marked with a red line into the
+ terminal and the cord with no marking into the
– terminal.
Make sure the metal leads (not the part covered with
vinyl insulation) are securely inserted into the speaker
terminals.
Make sure to match the projections on the SPEAKER
terminals and the speaker cords, and insert the cords
firmly to the SPEAKER terminals on the unit.
Note
Do not connect speakers other than those supplied with this
unit.
Power cord
Connect the power cord to a wall outlet after all
other connections have been made.
If the plug does not fit the wall socket, detach the
supplied plug adaptor (only for models supplied
with an adaptor).
When you plug in the unit for the first time
after purchase, demonstration images appear
on the display automatically. (By default, the
display lights up and the demonstration images
are displayed even when the unit is turned off.)
To cancel the demonstration, see "Canceling
automatic demonstration" (page 21).
DAB wire antenna (UK model only)
18
GB
With a DAB external antenna, you can obtain a
higher DAB broadcast sound quality. It is
recommended that you use the supplied DAB wire
antenna for only temporarily until you install a DAB
external antenna (optional).
75 coaxial cable with F male type connector

will be needed to install the DAB external antenna
(optional).