Bowflex Ultimate 2 Assembly Instructions Manual page 24

23
After installing the Rod Box in Step 7, install the Rod Retainer.
STEP 7B
Parts:
• 1 Rod Box Retainer
Tool:
• Phillips Head Screw Driver
Note: Rod Box screws must be installed before
proceeding.
7B-1 Remove both screws connecting the backing
plate and the face plate (See Figure A).
7B-2 Stand facing the rear of the Bowflex Ultimate
unit. Place the backing plate (larger piece), with the
curved side facing up, in between the two right-side
50 lb. rods (See Figure B). Verify that the notched lip
of the backing plate is located in the slot of the Box
Frame.
7B-3 Match up the face plate (thinner piece) to the backing
plate on the outside of the rod box. Make sure that
the notched lip of both backing plates are touching
and that the holes are aligned.
7B-4 Fasten both screws into the lined up holes (See
Figure C). Tighten until snug and then another
quarter turn.
Rod Box Retainer (screws are pre-installed)
Face
Place Backing
Plate
Assembling Your Bowflex Ultimate
2
®
Notched Lip
Qty: 2
Self Threading Screws (#10 x 1")
Curved Side
®
Unscrew
Figure A
Backing Plate
Rod Box
Figure B
Face Plate
Figure C
2
Insert into slot of
Rod Box Frame