Bowflex Ultimate 2 Assembly Instructions Manual page 21

The cables that retract the locking pins may
stretch with use. If the locking pins do not fully
retract or interfere with the side plates, make
the following adjustment.
Cable Adjustment (Requires Two People)
1. Position the base somewhere between the two
locking positions.
2. Pull the handle until it is in the most compressed
position.
3. Place a 1/4" or adjustable wrench on the Adjusting
Barrel and use a 1/4" or adjustable wrench to loosen
the locking nut. (See Detail B)
4. Rotate the Adjusting Barrel clockwise to increase
the cable tension. The Locking Pins should be as
close to the Side Plates as possible without making
contact. (See Detail A)
5. Test the adjustment by releasing the handle and
rotating the base to a locking hole. Make sure pin
securely engages with the locking hole then pull the
handle and make sure the unit moves freely.
6. Repeat the procedure for both sides if necessary.
7. Tighten Lock Nuts against Adjusting Barrel.
Assembling Your Bowflex Ultimate
Make sure Locking Pin is as close
as possible without making
contact with Side Plate
2
®
between the locking positions.
Adjusting Barrel
Detail A
Pull handle and position base
Locking Nut
Detail B
20