Exmark ULTRAVAC BAGGER 126-6954 Setup Instructions page 9

1. Blower
2. Belt cover
8. Install the knob and its hardware (reference
Figure 14).
Installing the Hopper Assembly
1. Lay the hopper assembly down as shown in
Figure 21.
1. Lower bagger mount bar
2. Remove the hairpin from the mount pin and pull the
mount pin out of the frame mount barrel (reference
Figure 22).
3. Pick up the frame legs and hook the notch onto the
lower mount bar (see Figure 21).
4. Lift the hopper assembly and pivot it upward towards
the back of the unit (see Figure 22).
Figure 20
3. Deck lip
Figure 21
2. Frame notch
g037432
1. Rotate hopper assembly
2. Rear bumper
3. Mount bracket
5. Continue to push the hopper assembly forward until
it contacts the mount bracket.
6. Install the mount pin into the frame mount barrel.
7. Align the holes in the mount pin and frame mount
barrel and insert the hairpin to lock the hopper
assembly into place.
8. Raise the hopper and install the bag assemblies
by inserting the hook portion into the slots in the
g037114
bagger support rods.
9. Close and latch the hood.
Assembling the Tubes
1. Slip the upper and the lower tubes together.
2. Insert the upper tube into the hopper seal – push in
then pull out so that the seal is extended outward.
3. Align the dimple on the upper tube with the end of
hopper seal and center between the two screws as
shown in Figure 23.
9
Figure 22
4. Frame mount barrel
5. Hairpin
6. Mount pin
g037115