Exmark ULTRAVAC BAGGER 126-6954 Setup Instructions page 3

Installing the Mount Brackets
1. Raise the deck to the transport position. Raise the
back of the machine up and support the machine
with jack stands.
CAUTION
Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands or
equivalent support.
2. Remove the rear tires from the machine.
3. Remove and retain the rear weight and its mounting
hardware (if applicable–see Figure 1).
4. Remove the nuts from the studs on the bottom
of each hydro as shown in Figure 1. Install the
transmission support bracket and secure with nuts.
Remove and retain the torx bolts on the sides of the
rear styling bracket.
1. Retain nuts
2. Transmission support
bracket
5. Place the RH bagger support tab onto the inside
of the mainframe. Align the front hole of the
RH bagger support bracket with the transmission
support frame and secure using 3/8-16 x 1 inch hex
screw, washer, and 3/8 inch flanged nyloc nut (see
Figure 2).
Figure 1
3. Rear weight
4. Torx bolts
1. RH bagger support bracket 5. 3/8 inch washer
2. RH bagger support tab
3. Transmission support
frame
4. Front hole
6. Mount the RH bagger brackets to the muffler guard
and bagger support bracket using 3/8-16 x 1 inch hex
screw and 3/8 inch flanged nyloc nut (see Figure 3).
g189729
1. RH bagger support bracket 6. 3/8 inch flanged nyloc nut
2. RH side bracket
3. 5/16 inch flanged nyloc nut 8. 3/8 inch washer
4. 5/16 inch washer
5. 5/16-18 x 3 1/2 inch hex
screw
3
Figure 2
RH Side Shown
6. 3/8 inch flanged nyloc nut
7. 3/8-16 x 1 inch hex screw
Figure 3
RH Side Shown
7. 3/8-16 x 1 inch hex screw
9. RH bagger bracket
10. Muffler guard
g189829
g189867