Exmark ULTRAVAC BAGGER 126-6954 Setup Instructions page 5

1. Weight
2. Mount channel
3. Weight bracket plate
For 48 Inch Deck Only:
Remove and retain the two mounting nuts on the
top side of the caster weight. Install the extra flat
weight on top of the caster weight and secure with
the two nuts (see Figure 7).
1. Nut
2. Flat weight
2. Install one removable caster weight on each caster
arm as shown in Figure 8.
Figure 6
4. Tabbed weight bracket
plate
5. 3/8-16 x 2 1/2 inch square
head bolt
6. 3/8 inch whizlock nut
Figure 7
3. Caster weight
1. Bolt
2. Knob
g185955
3. Insert the bolt through the bracket hole and install
the washer and knob.
4. Tighten the knob on weight assembly until the
weight is clamped securely to the caster arm.
Note: The portions of the UltraVac collection
system that are not bolted to the mower are designed
to be installed or removed in their entirety. Do
Not operate the mower with only a portion of the
UltraVac installed.
Installing the Belt Cover Bracket
1. Remove and retain the discharge deflector and its
mounting hardware.
2. Lower the deck fully. Remove and retain the
standard right side belt cover, wireform bracket and
its hardware.
3. Install the belt cover bracket.
• 483, 523, 484, and 524 Decks: Use two 3/8-16
x 1 1/4 inch carriage bolts and two 3/8 inch
flanged nyloc nuts as shown in Figure 9.
g037628
5
Figure 8
3. Washer
4. Caster weight
g037183