Exmark ULTRAVAC BAGGER 126-6954 Setup Instructions page 8

1. Nut
3. Mount the blower on the deck by inserting the
mounting pin into the tube welded to the rear corner
of the deck. Pivot the blower until the front pin
engages the slot in the deck. Adjust the position of
the front pin if necessary to engage the slot. Use the
latch to lock the blower in this position. Adjust the
tension on the latch to hold the blower up to the
deck, yet allow for release by hand.
1. Slot
2. Front pin
3. Blower latch
4. Pull the spring loaded idler back and slip the belt
over the top deck sheave. The belt should be routed
as shown in Figure 18.
Figure 16
2. Belt guide
Figure 17
4. Mounting pin
5. Deck tube
g189941
1. Spring loaded idler
2. Impeller sheave
5. Position the belt cover at an angle and slide it under
the mower frame (see Figure 19).
g189943
1. Blower
2. Belt cover
6. Push down on the back of the cover and slide it
backwards under the blower.
7. With the belt cover resting on the deck, slide it
forward until it is seated under both lips on the deck.
8
Figure 18
View from Top of Blower
3. Fixed idler
4. Deck sheave
Figure 19
3. Mower frame
g189695
g037117