Juniper SRX5400 Manual page 20

SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference
Description
Software release
Cables and connectors
Controls
Supported slots
20
NOTE: When installing an SRX5K-MPC in an SRX5600 or SRX5800 Services
Gateway:
If the session-distribution-mode
the CLI command:
user@host set security forwarding-process application-services
session-distribution-mode
The SRX5K-MPC defaults to hash-based mode automatically even if
existing SRX5K-MPC or non-MPCs are installed. You cannot set the
session-distribution-mode
If the session-distribution-mode
and the MIC is installed in the device, then the SRX5K-MPC will remain
offline, and the services gateway generates a major alarm and logs the
event for troubleshooting. You must explicitly configure the
session-distribution-mode
user@host set security forwarding-process application-services
session-distribution-mode hash-based
When installing an SRX5K-MPC in an SRX5400 Services Gateway, the
session-distribution-mode
configured or set as the default. The normal mode is not supported.
A 9% drop is observed for PPS (throughput) when moving from session
mode to hash mode (for SRX5K-MPC or non-MPCs), whereas no drop in
performance is observed on CPS (connection per second) and session
capacity numbers.
For more information about the CLI command, see the Junos OS
documentation at
MPC with slots for two MICs
Junos OS Release 12.1x46-D10
Slots for two MICs
One ejector knob each for MIC slots
the adjacent MIC.
SRX5400–Any slot except bottom slot
SRX5600–Any slot except bottom slots
SRX5800–Any slot except center slots
has not been explicitly configured using
to .
normal
has been explicitly configured to
using the CLI command:
will only function when
www.juniper.net/techpubs/
and . Pull the ejector knob to unseat and partially eject
0 1
0
or
0 1
or
0 1
Copyright © 2014, Juniper Networks, Inc.
normal
mode is
hash-based
.
,