Juniper SRX5400 Manual page 35

Description
Software release
Cables and connectors
Controls
Supported Slots
Power Requirement
Weight
LEDs
Copyright © 2014, Juniper Networks, Inc.
Gigabit Ethernet switch that is connected to the embedded CPU complex on all
components.
Switch fabric—Provides the switching functions for the IOCs.
Control FPGA—Provides the Peripheral Component Interconnect (PCI) interface to
the Routing Engine.
1000Base-T Ethernet controller—Provides a 1-Gbps Ethernet link between the Routing
Engines.
Ethernet switch—Provides 1-Gbps link speeds between the Routing Engine and the
IOCs.
Circuits for chassis management and control.
Power circuits for the Routing Engine and SCB.
SCB with slot for Routing Engine
Junos OS Release 9.2 and later
Slot for Routing Engine
None
SRX5400–Only bottom slot
SRX5600–Only bottom slots
SRX5800–Only center slots
150 W
Approximately 10 lb (4.5 kg)
OK/FAIL LED, one bicolor:
Green–The SCB is operating normally.
Red–The SCB has failed and is not operating normally.
Off–The SCB is powered down.
FABRIC ONLY LED:
Green–The SCB is operating in fabric-only mode.
Off–The SCB is operating in fabric/control board mode.
FABRIC ACTIVE LED:
Green–The fabric is in active mode.
Switch Control Board SRX5K-SCB
0
0 and 1
0 , 1 , and 2/6
35