Locking And Unlocking With Smart Entry And Start System - Toyota AURION Owner's Manual

KEYS AND DOORS
—Locking and unlocking with
smart entry and start system
When you carry the registered key with smart
entry and start system into the activation
area, you can lock and unlock all the doors
without inserting the key into the keyholes.
For further information of activation area, see
"Smart entry and start system" on page 25
in this Section.
Locking operation
Press the lock button on the driver's out-
side door handle slowly and firmly. All the
doors lock simultaneously. At this time,
the turn signal lights flash once.
NOTICE
In the following cases, the doors cannot
be locked by operating the lock button
and a beep will sound as an indicator:
When any of the doors are not secure-
D
ly closed. A beep will sound continu-
ously for 10 seconds.
When the engine is not turned off. A
D
beep will sound continuously.
When the key is left in the vehicle. A
D
beep will sound continuously for 2 se-
conds.
30
When attempting to lock the driver's
D
door with the key near a window or a
door handle. A beep will sound con-
tinuously for 2 seconds.
The beep may not sound if the key is
on the instrument panel, on the parcel
shelf, in the glove box, on the floor, etc.
Unlocking operation
Grasp the driver's outside door handle
(sensors are located on the underside
door handle). All the side doors unlock
simultaneously. At this time, the turn sig-
nal lights flash twice.
The doors may not unlock if the handle is
grasped too quickly. Be sure to confirm that
the doors are unlocked before pulling the
door handle. If the doors do not open when
the handle is pulled, return the handle to its
original position.
Wearing gloves may slow response time.
NOTICE
The doors cannot be unlocked via the
smart entry and start system for three
seconds after the doors have been
locked.